Ipx Commands - Allied Telesis AT-9108 Manual

IPX Commands

IPX Commands
Command
config ipxmaxhops <number>
config ipxroute add [<dest_netid> | default]
<next_hop_id> <next_hop_node_addr>
<hops> <tics>
config ipxroute delete [<dest_netid> | default]
<next_hope_netid>
<next_hope_node_addr>
config ipxservice add <service_type>
<service_name> <netid> <mac_address>
<socket> <hops>
config ipxservice delete <service_type>
<service_name> <netid> <mac_address>
<socket>
config vlan <name> xnetid <netid> [enet_ii |
enet_8023 | enet_8022 | enet_snap]
disable type20 forwarding {vlan <name>}
enable type20 forwarding {vlan <name>}
show ipxconfig {vlan <name>}
show ipxroute {vlan <name> | xnetid <netid>
| origin [static | rip | local]}
show ipxservice {vlan <name> | xnetid
<netid> | origin [static | sap | local]}
show ipxstats {vlan <name>}
unconfig vlan <name> xnetid
xping {continuous} {size <n>} <netid>
<mac_address>
30
Description
Configures the IPX maximum hop count when forwarding IPX
packets. The default setting is 16. Change this only if NetWare Lin
Services Protocol (NLSP) is running in the IPX network.
Adds a static IPX route entry in the IPX route table. Specify:
next_hop_id — The NetID of the neighbor IPX network.
next_hop_node_addr — The node address of the next IPX
router.
hops — The maximum hop count.
tics — The timer delay value.
Up to 64 static routes can be entered.
Removes a static IPX route entry from the route table.
Adds a static entry to the IPX service table. Specify:
service_type — The service type.
service_name — The service name.
netid — The IPX network identifier of the server.
mac_address — The MAC address of the server.
socket — The IPX port number on the server.
hops — The number of hops (for SAP routing purposes).
Deletes an IPX service from the service table.
Configures a VLAN to run IPX routing. Specify:
enet_ii — Uses standard Ethernet 2 header.
enet_8023 — Uses IEEE 802.3 length field, but does not
include the IEEE 802.2 LLC header.
enet_8022 — Uses standard IEEE format and uses IEEE 802.2
LLC header.
enet_snap — Adds Subnetwork Access Protocol (SNAP)
header to IEEE 802.2 LLC header.
Disables the forwarding of IPX type 20 packets.
Enables the forwarding of IPX type 20 (NetBIOS inside IPX) packets
from one or more ingress VLANs. The default setting is disabled.
Displays IPX configuration information for one or all VLANs.
Displays the IPX routes in the route table.
Displays IPX services learned by way of SAP.
Displays IPX packet statistics for the IPX router, and one or all VLANs.
Removes the IPX NetID of a VLAN.
Pings an IPX node. If continuous is not specified, 4 pings are sent.
The default ping packet size is 256 data bytes. The size between 1
and 1,484 bytes.