Chapter 25: Quality Of Service (Qos) Commands - Allied Telesis AT-GS900M Series User Manual

Chapter 25
Quality of Service (QoS) Commands
"DISABLE QOS" on page 442
"ENABLE QOS" on page 443
"PURGE QOS" on page 444
"SET QOS DSCP" on page 445
"SET QOS HWPRIORITY" on
page 446
"SET QOS HWQUEUE" on
page 448
"SET QOS SCHEDULING" on
page 449
"SHOW QOS" on page 450
"SHOW QOS DSCP" on
page 451
"SHOW QOS HWPRIORITY" on
page 452
"SHOW QOS HWQUEUE" on
page 453
"SHOW QOS SCHEDULING" on
page 454
Section IV: Security and Traffic Control
The QoS commands are summarized in Table 52.
Table 52. QoS Commands
Command
AT-GS900M Series CLI Reference
Description
Sets the switch to prioritize forwarding
performance over Quality of Service
(QoS).
Sets the switch to prioritize Quality of
Service (QoS) over forwarding
performance.
Initializes QoS settings.
Changes the DSCP table.
Changes the QoS priority map.
Changes the weight ratio to the queue.
Changes the QoS scheduling method.
Displays the QoS settings on the switch.
Displays the DSCP table on the switch.
Displays the QoS priority mapping table
on the switch.
Displays the settings of queue weight on
the switch.
Displays the settings of QoS scheduling
on the switch.
441