Scanning - Standard Horizon HX890 Owner's Manual

8.8.1 Setting up the Multi Watch Operation
Press and hold

key
1. Press the [CH▼]/[CH▲] key to select "DUAL" or "TRIPLE".
2. Press the [ENTER] soft key to store the selected setting.
3. Press the [CLR] key to return to radio operation.
8.8.2 Starting the Dual Watch
1. Press the SQL key, then press the [CH▼]/[CH▲] key until the background
noise disappears.
2. Press the [CH▼]/[CH▲] key to select a channel you wish to watch.
3. P ress [◄]/[►] key repeatedly until the [DUAL WATCH]
soft key is displayed at the bottom of the screen, press the
[DUAL WATCH] soft key.
The radio will monitor the priority channel and the watch
channel that was selected in step 2.
If a signal is received on the watch channel selected in step 2, the HX890
will periodically dual watch to the priority channel.
4. T o stop dual watch, press the [◄]/[►] key repeatedly, then press the [DUAL
WATCH] soft key again.
When selecting "TRIPLE" in the CH SETUP menu, [TRIPLE WATCH] will be
displayed as the soft key instead of [DUAL WATCH].
The priority channel may be changed from CH16 (default) to another
channel. Refer to section "14.7 PRIORITY CHANNEL".
8.9

SCANNING

The HX890 will automatically scan channels programmed into the preset
channel memory and also the scan channel memory, and the last selected
weather channel.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming transmis-
sion. The radio will automatically start scanning again after the transmission
stops.
26
CH SETUP

( / key)
SELECT
MULTI WATCH

(
( key)
NOTE
SELECT

/ key)
(
CH SETUP
MULTI WATCH
DUAL
TRIPLE
BACK
RX USA HI
22
P-SET
10
USCG
LAT 33 ° 37.1200
LON 118 ° 09.5822
TIME LOC 09:56:56
key)
ENTER
DW
16
MEM
s
W
AM