ZyXEL Communications ISG50-ISDN User Manual page 726

Integrated service gateway
Hide thumbs Also See for ISG50-ISDN:
Table of Contents

Advertisement

Chapter 55 File Manager
These files have the same syntax, which is also identical to the way you run CLI commands
manually. An example is shown below.
Figure 488 Configuration File / Shell Script: Example
# enter configuration mode
configure terminal
# change administrator password
username admin password 4321 user-type admin
# configure lan1
interface lan1
ip address 172.23.37.240 255.255.255.0
ip gateway 172.23.37.254 metric 1
exit
# create address objects for remote management / to-Device firewall rules
# use the address group in case we want to open up remote management later
address-object TW_SUBNET 172.23.37.0/24
object-group address TW_TEAM
address-object TW_SUBNET
exit
# enable Telnet access (not enabled by default, unlike other services)
ip telnet server
# open WAN-to-Device firewall for TW_TEAM for remote management
firewall WAN Device insert 4
sourceip TW_TEAM
service TELNET
action allow
exit
write
While configuration files and shell scripts have the same syntax, the ISG50 applies configuration
files differently than it runs shell scripts. This is explained below.
Table 290 Configuration Files and Shell Scripts in the ISG50
Configuration Files (.conf)
Resets to default configuration.
Goes into CLI Configuration mode.
Runs the commands in the configuration file.
You have to run the example in
is run in Privilege mode. If you remove the first command, you have to run the example as a
configuration file because the rest of the commands are executed in Configuration mode.
Comments in Configuration Files or Shell Scripts
In a configuration file or shell script, use "#" or "!" as the first character of a command line to have
the ISG50 treat the line as a comment.
Your configuration files or shell scripts can use "exit" or a command line consisting of a single "!" to
have the ISG50 exit sub command mode.
Note: "exit" or "!'" must follow sub commands if it is to make the ISG50 exit sub
command mode.
726
Shell Scripts (.zysh)
Goes into CLI Privilege mode.
Runs the commands in the shell script.
Figure 488 on page 726
as a shell script because the first command
ISG50 User's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Isg50

Table of Contents