ZyXEL Communications ISG50-ISDN User Manual page 682

Chapter 52 System
Table 274 Configuration > System > WWW > Service Control (continued)
LABEL
Enable
Server Port
Admin/User Service
Control
Add
Edit
Remove
Move
#
Zone
Address
Action
Authentication
Client Authentication
Method
Apply
Reset
682
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address
that matches the IP address(es) in the Service Control table to access the
ISG50 Web Configurator using HTTP connections.
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service to access the
ISG50.
Admin Service Control specifies from which zones an administrator can use
HTTP to manage the ISG50 (using the Web Configurator). You can also
specify the IP addresses from which the administrators can manage the
ISG50.
User Service Control specifies from which zones a user can use HTTP to log
into the ISG50. You can also specify the IP addresses from which the users
can access the ISG50.
Click this to create a new entry. Select an entry and click Add to create a new
entry after the selected entry.
Double-click an entry or select it and click Edit to be able to modify the
entry's settings.
To remove an entry, select it and click Remove. The ISG50 confirms you
want to remove it before doing so. Note that subsequent entries move up by
one when you take this action.
To change an entry's position in the numbered list, select the method and
click Move to display a field to type a number for where you want to put it
and press [ENTER] to move the rule to the number that you typed.
This is the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ISG50's (non-
configurable) default policy. The ISG50 applies this to traffic that does not
match any other configured rule. It is not an editable rule. To apply other
behavior, configure a rule that traffic will match so the ISG50 will not have to
use the default policy.
This is the zone on the ISG50 the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is
allowed or denied to access.
This displays whether the computer with the IP address specified above can
access the ISG50 zone(s) configured in the Zone field (Accept) or not
(Deny).
Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the Auth. method
screen.
Click Apply to save your changes back to the ISG50.
Click Reset to return the screen to its last-saved settings.
ISG50 User's Guide