What You Can Do In This Chapter; What You Need To Know; Before You Begin - ZyXEL Communications ISG50-ISDN User Manual

Integrated service gateway

Hide thumbs Also See for ISG50-ISDN:

Table of Contents

Chapter 32 LCR

only has LCR1 assigned to it, so extensions that are part of Research cannot use outbound line

Figure 342 LCR Components Example

32.1.1 What You Can Do in this Chapter

Use the LCR screen to configure settings for your dialing rules for outbound calls routing. See

Section 32.2 on page

The following terms and concepts may help you as you read through the chapter.

LCRs are made up of two components. The first part of an LCR is a set of 1 or more outbound line

of pattern of digits that distinguish each individual LCR.

LCRs define which outbound line group(s) that authority groups, trusted SIP peers or outbound line

groups can use to make an outgoing call. This is done via group management, see

526. Once you create an LCR, you can associate it with:

• Authority Groups - give all the extensions contained in an authority group the right to use the

outbound line groups configured in the LCR.

• Trusted SIP Peers - give the telephones connected to the SIP peer the right to call the ISG50

and then dial out from the ISG50 using the outbound line groups configured in the LCR.

• Outbound Line Groups - give anyone calling in via the associated outbound line group the right

to use the ISG50 to make calls via the outbound line groups configured in the LCR.

Outbound Line Group

The outbound lines define a connection between the ISG50 and PSTN, ISDN, ITSP or your trusted

Section 30.1 on page 477

Before you start to configure an LCR, please consider the following.

Chapter 30 on page

477). The second part of an LCR is a set of dial conditions, or a set

Dial Condition

Dial Condition

for more information.

Chapter 33 on

ISG50 User's Guide