Ftp; Configuring Ftp - ZyXEL Communications ISG50-ISDN User Manual

Integrated service gateway

Hide thumbs Also See for ISG50-ISDN:

Table of Contents

Table 278 Configuration > System > TELNET (continued)

52.10 FTP

You can upload and download the ISG50's firmware and configuration files using FTP. To use this

feature, your computer must have an FTP client. Please see

information about firmware and configuration files.

To change your ISG50's FTP settings, click Configuration > System > FTP tab. The screen

appears as shown. Use this screen to specify from which zones FTP can be used to access the

ISG50. You can also specify from which IP addresses the access can come.

Figure 477 Configuration > System > FTP

ISG50 User's Guide

This the index number of the service control rule.

The entry with a hyphen (-) instead of a number is the ISG50's (non-configurable)

default policy. The ISG50 applies this to traffic that does not match any other

configured rule. It is not an editable rule. To apply other behavior, configure a rule

that traffic will match so the ISG50 will not have to use the default policy.

This is the zone on the ISG50 the user is allowed or denied to access.

This is the object name of the IP address(es) with which the computer is allowed

or denied to access.

This displays whether the computer with the IP address specified above can

access the ISG50 zone(s) configured in the Zone field (Accept) or not (Deny).

Click Apply to save your changes back to the ISG50.

Click Reset to return the screen to its last-saved settings.

Chapter 52 System

Chapter 55 on page 725