ZyXEL Communications ISG50-ISDN User Manual page 712

Chapter 53 Log and Report
Table 285 Configuration > Log & Report > Log Setting > Edit (System Log) (continued)
LABEL
E-mail Server 2
#
Log Category
System log
E-mail Server 1
E-mail Server 2
Log Consolidation
Active
Log Consolidation
Interval
OK
Cancel
712
DESCRIPTION
Use the E-Mail Server 2 drop-down list to change the settings for e-mailing logs to
e-mail server 2 for all log categories.
Using the System Log drop-down list to disable all logs overrides your e-mail server
2 settings.
enable normal logs (green check mark) - e-mail log messages for all categories to
e-mail server 2.
enable alert logs (red exclamation point) - e-mail alerts for all categories to e-mail
server 2.
This field is a sequential value, and it is not associated with a specific address.
This field displays each category of messages. It is the same value used in the
Display and Category fields in the View Log tab. The Default category includes
debugging messages generated by open source software.
Select which events you want to log by Log Category. There are three choices:
disable all logs (red X) - do not log any information from this category
enable normal logs (green check mark) - create log messages and alerts from this
category
enable normal logs and debug logs (yellow check mark) - create log messages,
alerts, and debugging information from this category; the ISG50 does not e-mail
debugging information, however, even if this setting is selected.
Select whether each category of events should be included in the log messages when
it is e-mailed (green check mark) and/or in alerts (red exclamation point) for the e-
mail settings specified in E-Mail Server 1. The ISG50 does not e-mail debugging
information, even if it is recorded in the System log.
Select whether each category of events should be included in log messages when it
is e-mailed (green check mark) and/or in alerts (red exclamation point) for the e-
mail settings specified in E-Mail Server 2. The ISG50 does not e-mail debugging
information, even if it is recorded in the System log.
Select this to activate log consolidation. Log consolidation aggregates multiple log
messages that arrive within the specified Log Consolidation Interval. In the View
Log tab, the text "[count=x]", where x is the number of original log messages, is
appended at the end of the Message field, when multiple log messages were
aggregated.
Type how often, in seconds, to consolidate log information. If the same log message
appears multiple times, it is aggregated into one log message with the text
"[count=x]", where x is the number of original log messages, appended at the end of
the Message field.
Click this to save your changes and return to the previous screen.
Click this to return to the previous screen without saving your changes.
ISG50 User's Guide