ZyXEL Communications ISG50-ISDN User Manual page 187

Table 26 Dashboard (continued)
LABEL
Virtual Device
Device
Name
Status
Zone
IP Address
Mask
1~4
FXS
Device
Information
System Name
Model Name
Serial Number
MAC Address
Range
Firmware
Version
System Status
System
Uptime
ISG50 User's Guide
DESCRIPTION
Hover your cursor over a LED, interface or slot to view details about the status of the
ISG50 connections. See Section 1.4.1 on page 33
interface or slot appears grayed out.
This identifies a device installed in one of the ISG50's USB ports.
The configuration name of the interface.
This field displays the current status of each Ethernet interface. The possible values
depend on what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports associated with it or the
Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected. This field displays
the port speed and duplex setting (Full or Half).
For cellular (3G) interfaces, see
This field displays the zone to which the interface is currently assigned.
This field displays the current IP address assigned to the interface.
This field displays the current subnet mask assigned to the interface.
FXO:
Off - The port is not connected.
Blinking - The line is ringing.
On - A phone is plugged into the port and connected.
BRI:
Off - The port is not connected.
Blinking - The port has at least one connection active.
On - A phone is plugged into the port and connected.
Off - The port is not connected or on-hook
Blinking - The phone is ringing for an inbound call.
On - The port is off-hook.
This field displays the name used to identify the ISG50 on any network. Click the icon to
open the screen where you can change it. See
This field displays the model name of this ISG50.
This field displays the serial number of this ISG50.
This field displays the MAC addresses used by the ISG50. Each physical port has one MAC
address. The first MAC address is assigned to physical port 1, the second MAC address is
assigned to physical port 2, and so on.
This field displays the version number and date of the firmware the ISG50 is currently
running. Click the icon to open the screen where you can upload firmware. See
55.3 on page 731.
This field displays how long the ISG50 has been running since it last restarted or was
turned on.
for LED descriptions. An unconnected
Section 12.5 on page 251 for the status that can appear.
Section 52.2 on page
Chapter 9 Dashboard
666.
Section
187