Manually Adding Hosts To The Sdt Connector Gateway - Tripp Lite B092-016 Owner's Manual

Chapter 6: Secure SSH Tunneling & SDT Connector
6.2.5

Manually adding hosts to the SDT Connector gateway

For each gateway, you can manually specify the network connected hosts that will be accessed through that Console Server;
and for each host, specify the services that will used in communicating with the host
• Select the newly added gateway and click the Host icon
(Alternatively select File: New Host)
• Enter the IP or DNS Host Address of the host (if this is a DNS address, it must be resolvable by the gateway)
• Select which Services are to be used when accessing the new host. A range of service options are pre-configured in the
default SDT Connector client (RDP , VNC, HTTP , HTTPS, Dell RAC, VMWare etc). However if you wish to add new services to
the range then proceed to the next section (Adding a new service) then return here
• Optionally, you can enter a Descriptive Name for the host to be displayed instead of the IP or DNS address, as well as
any Notes or a Description of this host (such as its operating system/release, or anything special about its configuration)
• Click OK
to create a host that will be accessible via this gateway.
88