Delayed Configuration Commit - Tripp Lite B092-016 Owner's Manual

Chapter 11: System Management
After saving a local configuration backup, you may choose to use it as the alternate default configuration. When the Console
Server is reset to factory defaults, it will then load your alternate default configuration instead of its factory settings:
• To set an alternate default configuration, check Load On Erase and click Apply
Note: Before selecting Load On Erase please ensure you have tested your alternate default configuration by clicking Restore
If for some reason your alternate default configuration causes the Console Server to become unbootable recover your unit to
factory settings using the following steps:
• If the configuration is stored on an external USB storage device, unplug the storage device and reset to factory defaults as
per section 11.1 of the user manual
• If the configuration is stored on an internal USB storage device reset to factory defaults using a specially prepared USB
storage device:
o The USB storage device must be formatted with a Windows FAT32/VFAT file system on the first partition or the
entire disk, most USB thumb drives are already formatted this way
o The file system must have the volume label: OPG_DEFAULT
o Insert this USB storage device into an external USB port on the Console Server and reset to factory defaults as
per section 11.1
After recovering your Console Server, ensure the problematic configuration is no longer selected for Load On Erase

11.5 Delayed Configuration Commit

The Delayed Config Commit mode allows the grouping or queuing of configuration changes and the simultaneous application
of these changes to a specific device. For example, changes to authentication methods or user accounts may be grouped and
run once to minimize system downtime. To enable:
• Check the Delayed Config Commits button under System: Administration
• Click Apply
• The Commit Config icon
Out icons
To queue then run configuration changes:
• Firstly apply all the required changes to the configuration e.g. modify user accounts, amend authentication method,
enable OpenVPN tunnel or modify system time
• Click the Commit Config button. This will generate the System: Commit Configuration screen displaying all the
configurators to be run
will now be displayed in top right-hand corner of the screen between the Backup and Log
167