Tripp Lite B092-016 Owner's Manual page 182

Chapter 14: Command Line Configuration
SDT mode
To enable access over SSH to a host connected to serial port 5:
# config -s config.ports.port5.mode=sdt
# config -s config.ports.port5.sdt.ssh=on
To configure a username and password when accessing this port with Username = user1 and Password = secret:
# config -s config.ports.port#.sdt.username=user1
# config -s config.ports.port#.sdt.password=secret
Terminal server mode
Enable a TTY login for a local terminal attached to serial port 5:
# config -s config.ports.port5.mode=terminal
# config -s config.ports.port5.terminal=[vt220 | vt102 | vt100 | linux | ansi]
The default terminal is vt220
Serial bridge mode
Create a network connection to a remote serial port via RFC-2217 on port 5:
# config -s config.ports.port5.mode=bridge
Optional configurations for the network address of RFC-2217 server of 192.168.3.3 and TCP port used by the RFC-2217
service = 2500:
# config -s config.ports.port5.bridge.address=192.168.3.3
# config -s config.ports.port5.bridge.port=2500
To enable RFC-2217 access: # config -s config.ports.port5.bridge.rfc2217=on
To redirect the serial bridge over an SSH tunnel to the server: # config -s config.ports.port5.bridge.ssh.enabled=on
Syslog settings
Additionally, the global system log settings can be set for any specific port, in any mode:
# config -s config.ports.port#.syslog.facility='facility'
'facility' can be:
Default
local 0-7
auth
authpriv
cron
daemon
ftp
kern
lpr
mail
news
user
uucp
# config -s config.ports.port#.syslog.priority='priority'
'priority' can be:
Default
warning
notice
Info
error
emergency
debug
critical
alert
182