Tripp Lite B092-016 Owner's Manual page 181

Chapter 14: Command Line Configuration
The following command will synchronize the live system with the new configuration:
# config -r serialconfig
Note: Supported serial port baud-rates are '50', '75', '110', '134', '150', '200', '300', '600',
'1200', '1800', '2400', '4800', '9600', '19200', '38400', '57600', '115200', and '230400'.
Supported parity values are 'None', 'Odd', 'Even', 'Mark' and 'Space'.
Supported data-bits values are '8', '7', '6' and '5'.
Supported stop-bits values are '1', '1.5' and '2'.
Supported flow-control values are 'Hardware', 'Software' and 'None'.
Additionally, before any port can function properly, the mode of the port needs to be set. Any port can be set to run in one
of the five possible modes (refer Chapter 4 for details): [Console Server mode | Device mode | SDT mode | Terminal server
mode | Serial bridge mode]. All these modes are mutually exclusive.
Console Server mode
The command to set the port in portmanager mode:
# config -s config.ports.port5.mode=portmanager
To set the following optional config elements for this mode:
Data accumulation period
Escape character
log level
Shell power command menu
RFC2217 access
Limit pot to 1 connection
SSH access
TCP access
telnet access
Unauthorized telnet access
# config -s config.ports.port5.delay=100
# config -s config.ports.port5.escapechar=%
# config -s config.ports.port5.loglevel=2
# config -s config.ports.port5.powermenu=on
# config -s config.ports.port5.rfc2217=on
# config -s config.ports.port5.singleconn=on
# config -s config.ports.port5.ssh=on
# config -s config.ports.port5.tcp=on
# config -d config.ports.port5.telnet
# config -d config.ports.port5.unauthtel
Device Mode
For a device mode port, set the port type to either ups, rpc, or enviro:
# config -s config.ports.port5.device.type=[ups | rpc | enviro]
For port 5 as a UPS port:
# config -s config.ports.port5.mode=reserved
For port 5 as an RPC port:
# config -s config.ports.port5.mode=powerman
For port 5 as an Environmental port:
# config -s config.ports.port5.mode=reserved
100 ms
% (default is ~)
2 (default is 0)
Enabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
181