Configuring Powered Computers To Monitor A Managed Ups - Tripp Lite B092-016 Owner's Manual
Console server management switch console server with poweralert console server
Hide thumbs
Also See for B092-016:
- Owner's manual (242 pages) ,
- Quick start manual (4 pages) ,
- Specification sheet (3 pages)
Table of Contents
Advertisement
Chapter 8: Power and Environment
8.2.3
Configuring powered computers to monitor a Managed UPS
Once you have added a Managed UPS, each server that is drawing power through the UPS should be setup to monitor the
UPS status as a Slave. This is done by installing the NUT package on each server, and setting up upsmon to connect to the
Console Server.
Refer to the NUT documentation for details on how this is done, specifically sections 13.5 to 13.10.
http://eu1.networkupstools.org/doc/2.2.0/INSTALL.html
An example upsmon.conf entry might look like:
• MONITOR managedups@192.168.0.1 1 username password Slave
• managedups is the UPS Name of the Managed UPS
• 192.168.0.1 is the IP address of the Console Server
• 1 indicates the server has a single power supply attached to this UPS
• username is the Username of the Managed UPS
• password is the Password of the Manager UPS
130
- Quick Links:
- Network Connection
- Serial Port Connection
Hide quick links:
Advertisement
Table of Contents
