General Linux Command Usage - Tripp Lite B092-016 Owner's Manual

Chapter 14: Command Line Configuration
To configure NSCA with the following settings:
NSCA encryption
NSCA password
NSCA check-in interval
NSCA port
user to run as
group to run as
# config -s config.system.nagios.nsca.enabled=on
# config -s config.system.nagios.nsca.encryption=BLOWFISH
# config -s config.system.nagios.nsca.secret=secret
# config -s config.system.nagios.nsca.interval=2
# config -s config.system.nagios.nsca.port=5650
# config -s config.system.nagios.nsca.user=User1
# config -s config.system.nagios.nsca.group=Group1
The following command will synchronize the live system with the new configuration:
# config –a

14.2 General Linux command usage

The Console Server platform is a dedicated Linux computer, optimized to provide access to serial consoles of critical server
systems and control network connected hosts. Being based around uClinux (a small footprint but extensible Linux), it embodies
a myriad of popular and proven Linux software modules for networking (NetFilter, IPTables), secure access (OpenSSH) and
communications (OpenSSL) and sophisticated user authentication (PAM, RADIUS, TACACS+ and LDAP).
Many components of the Console Server software are licensed under the GNU General Public License (version 2). You may
obtain a copy of the GNU General Public License at http://www.fsf.org/copyleft/gpl.html and source code will provided for any of
the components of the Software licensed under the GNU General Public License upon request. The Console Servers are built
on the 2.6 uClinux kernel as developed by the uClinux project. This is GPL code and source can be found: http://cvs.uclinux.
org.
BLOWFISH (can be: [ None | XOR | DES | TRPLEDES | CAST-256 | BLOWFISH |
TWOFISH | RIJNDAEL-256 | SERPENT | GOST ]
secret
5 minutes
5650 (defaults to 5667)
User1 (defaults to nsca)
Group1 (defaults to nobody)
199