Advanced Control Panel; System: Terminal; System: Shutdown / Reboot; System: Logout - Tripp Lite B092-016 Owner's Manual

Chapter 16: Thin Client

16.2 Advanced Control Panel

16.2.1 System: Terminal

Selecting System: Terminal on the control panel logs you in at the command line to the B092-016 Linux kernel. As detailed
in Chapters 14 and 15, this enables you to configure and customize your B092-016 using the config and portmanager
commands or general Linux commands.

16.2.2 System: Shutdown / Reboot

Clicking System: Shutdown on the control panel will shut down the B092-016 system. You will need to cycle the power to
reactivate the B092-01.
Similarly, by clicking System: Reboot, you will initiate a soft reset. With a soft reset, the B092-016 reboots with all settings
such as the assigned network IP address, preserved. However a soft reset disconnects all Users and ends any SSH sessions
that had been established.
A soft reset will also occur when you switch OFF power from the B092-016, and then switch the power back ON. However,
if you cycle the power while the unit is writing to flash, you could corrupt or lose data, so the software Shutdown or Reboot
from the control panel is the safer option.

16.2.3 System: Logout

Clicking System: Logout closes the local user log in session (and removes the control panel). However, this does not logout
remote users who may be logged into the B092-016 Console Server, or accessing attached devices using SSH tunneling.

16.2.4 Custom

The Custom button on the control panel enables you to customize your B092-016 by adding buttons to the control panel that
execute bash and other Linux commands you specify.

16.2.5 Status

These menu items give the user a snapshot of the serial port and IPMI device status.

16.2.6 Logs

These menu items give the user an audit log of B092-016 activity.
244