Dhcp Server - Tripp Lite B092-016 Owner's Manual

Chapter 14: Command Line Configuration
# config -s config.console.flow=Hardware
# config -s config.console.initstring=ATQ0V1H0
# config -s config.console.ppp.enabled=on
# config -s config.console.ppp.callback.enabled=on
# config -s config.console.ppp.callback.phone1=0800223665
# config -s config.console.ppp.username=user1
# config -s config.console.ppp.password=secret
To make the dialed connection the default route:
# config -s config.console.ppp.defaultroute=on
Please note that supported authentication types are 'None', 'PAP', 'CHAP' and 'MSCHAPv2'.
Supported serial port baud-rates are '9600', '19200', '38400', '57600', '115200', and '230400'.
Supported parity values are 'None', 'Odd', 'Even', 'Mark' and 'Space'.
Supported data-bits values are '8', '7', '6' and '5'.
Supported stop-bits values are '1', '1.5' and '2'.
Supported flow-control values are 'Hardware', 'Software' and 'None'.
If you do not wish to use out-of-band dial-in access please note that the procedure for enabling start-up messages on the
console port is covered in Chapter 15 - Accessing the Console Port.
The following command will synchronize the live system with the new configuration:
# config –a

14.1.20 DHCP server

To enable the DHCP server on the console management LAN, with settings:
Default lease time
Maximum lease time
DNS server1
DNS server2
Domain name
Default gateway
IP pool 1 start address
IP pool 1 end address
Reserved IP address
MAC to reserve IP for
Name to identify this host
Issue the commands:
# config -s config.interfaces.lan.dhcpd.enabled=on
# config -s config.interfaces.lan.dhcpd.defaultlease=200000
# config -s config.interfaces.lan.dhcpd.maxlease=300000
# config -s config.interfaces.lan.dhcpd.dns1=192.168.2.3
# config -s config.interfaces.lan.dhcpd.dns2=192.168.2.4
# config -s config.interfaces.lan.dhcpd.domain=company.com
# config -s config.interfaces.lan.dhcpd.gateway=192.168.0.1
# config -s config.interfaces.lan.dhcpd.pools.pool1.start=192.168.0.20
# config -s config.interfaces.lan.dhcpd.pools.pool1.end=192.168.0.100
# config -s config.interfaces.lan.dhcpd.pools.total=1
# config -s config.interfaces.lan.dhcpd.staticips.staticip1.ip=192.168.0.50
# config -s config.interfaces.lan.dhcpd.staticips.staticip1.mac=00:1e:67:82:72:d9
# config -s config.interfaces.lan.dhcpd.staticips.staticip1.host=John-PC
# config -s config.interfaces.lan.dhcpd.staticips.total=1
The following command will synchronize the live system with the new configuration:
# config –a
200000 seconds
300000 seconds
192.168.2.3
192.168.2.4
company.com
192.168.0.1
192.168.0.20
192.168.0.100
192.168.0.50
00:1e:67:82:72:d9
John-PC
197