Tripp Lite B092-016 Owner's Manual page 216

Chapter 15: Advanced Configuration
noauth No authentication or encryption is required. This is the minimum level of security.
auth Authentication will be required but encryption is not enforced. An authentication protocol (SHA or
MD5) and password will be required.
priv Enforces the use of encryption. This is the highest level of security and requires an encryption
protocol (DES or AES) and password in addition to the authentication protocol and password.
o Complete the Read Only Username. Enter the read only security name. This field is mandatory and must be
completed when configuring the Console Server for SNMPv3.
For a Security Level of auth, select the Auth. Protocol (SHA or MD5) and the Auth. Password. A password of
o
at least 8 characters is required.
For a Security Level of priv, select the Privacy Protocol (DES or AES) and the Privacy Password. AES is
o
recommended as it provides stronger privacy but requires more intense calculations. A password of at least 8
characters is required.
• Click Apply
• Setup serial ports and devices as per operational requirements such as UPS, RPC/PDU and EMD
• Copy the mibs from /etc/snmp/mibs on the Console Server product to a local directory using scp or Winscp. For example:
scp root@b095:/etc/snmp/mibs/*
• Using the snmpwalk and snmpget commands, the status information can be retrieved from any console server. For
example:
snmpwalk -Oa -v1 -M .:/usr/share/snmp/mibs -c public b095 STATUS-MIB::ogStatus
snmpget -Oa -v1 -M .:/usr/share/snmp/mibs -c public b095 OG-STATUSMIB::
ogSerialPortStatusSpeed.2
216