Common Settings - Tripp Lite B092-016 Owner's Manual

Chapter 4: Serial Port, Device and User Configuration
4.1.1

Common Settings

There are a number of common settings available for each serial port. These are independent of the mode in which the port
is being used. These serial port parameters must be set so they match the serial port parameters on the device which is
attached to that port.
• Select Serial & Network: Serial Port and click Edit
• Specify a label for the port
• Select the appropriate Baud Rate, Parity, Data Bits, Stop Bits and Flow Control for each port (and ensure they match the
settings for serial device that is connected). The Signaling Protocol is hard configured to be RS232
Note: The serial ports are all set at the factory to RS232 9600 baud, no parity, 8 data bits, 1 stop bit and Console Server
Mode. The baud rate can be changed to 2400 – 230400 baud using the management console. Lower baud rates (50, 75,
110, 134, 150, 200, 300, 600, 1200, 1800 baud) can be configured from the command line as detailed in Chapter 14
37