Tripp Lite B092-016 Owner's Manual page 107

Chapter 6: Secure SSH Tunneling & SDT Connector
Note: You can choose any TCP/IP addresses as long as they are addresses which are not used anywhere else on your network.
The From: address will be assigned to the Windows XP/2003 computer and the To: address will be used by the Console
Server. For simplicity, use the IP address as shown in the illustration above:
From: 169.134.13.1
To: 169.134.13.2
Alternately you can set the advanced connection and access on the Windows computer to use the Console Server defaults:
• Specify 10.233.111.254 as the From: address
• Select Allow calling computer to specify its own address
Also you could use the Console Server default username and password when you set up the new Remote Desktop User and
give this User permission to use the advance connection to access the Windows computer:
• The Console Server default Username is portXX where XX is the serial port number on the Console Server.
• The default Password is portXX
So to use the defaults for an RDP connection to the serial port 2 on the Console Server, you would have set up a Windows
user named port02
• When the PPP connection has been set up, a network icon will appear in the Windows task bar
Note: The above notes describe setting up an incoming connection for Windows XP . The steps are the same for Windows
2003, except that the setup screens present slightly differently:
Put a check in the box for Always allow directly connected devices such as palmtop.....
Also, the option to Set up an advanced connection is not available in Windows 2003 if RRAS is configured. If RRAS has
been configured, it is a simple task to enable the null modem connection for the dial-in configuration.
C. For earlier version Windows computers, follow the steps in Section B, above. To get to the Make New Connection button:
• For Windows 2000, click Start and select Settings. At the Dial-Up Networking Folder, click Network and Dial-up
Connections and click Make New Connection. Note: you first may need to set up a connection over the COM port using
Connect directly to another computer before proceeding to Set up an advanced connection
• For Windows 98, you double-click My Computer on the Desktop, then open Dial-Up Networking and double-click
107