Date & Time Settings; Dial-In Settings - Tripp Lite B092-016 Owner's Manual

Chapter 14: Command Line Configuration
Note: Not all devices have a management LAN interface.
To configure a failover device in case of an outage:
# config -s config.interfaces.wan.failover.address1='ip address'
# config -s config.interfaces.wan.failover.address2='ip address'
# config -s config.interfaces.wan.failover.interface=[ eth1 | console | modem ]
The network interfaces can also be configured automatically:
# config -s config.interfaces.wan.mode=dhcp
# config -s config.interfaces.lan.mode=dhcp
The following command will synchronize the live system with the new configuration:
# /bin/config –-run=ipconfig
The following command will synchronize the live system with the new configuration:
# config -r ipconfig
14.1.18 Date & Time settings
To enable NTP using a server at pool.ntp.org issue the following commands:
# config -s config.ntp.enabled=on
# config -s config.ntp.server=pool.ntp.org
Alternatively, you can manually change the clock settings:
To change running system time:
# date 092216452005.05
Then the following command will save this new system time to the hardware clock:
# /bin/hwclock -systohc
Alternatively, to change the hardware clock:
# /bin/hwclock -- set --date=092216452005.05
Then the following command will save this new hardware clock time as the system time:
# /bin/hwclock -hctosys
To change the timezone:
# config -s config.system.timezone=US/Eastern
The following command will synchronize the live system with the new configuration:
# config -r time

14.1.19 Dial-in settings

To enable dial-in access on the DB9 serial port from the command line with the following attributes:
Local IP Address
Remote IP Address
Authentication Type:
Serial Port Baud Rate:
Serial Port Flow Control:
Custom Modem Initialization:
Callback phone
User to dial as
Password for user
Run the following commands:
# config -s config.console.ppp.localip=172.24.1.1
# config -s config.console.ppp.remoteip=172.24.1.2
# config -s config.console.ppp.auth=MSCHAPv2
# config -s config.console.speed=115200
Format is MMDDhhmm[[CC]YY][.ss]
172.24.1.1
172.24.1.2
MSCHAPv2
115200
Hardware
ATQ0V1H0
0800223665
user1
secret
Format is MMDDhhmm[[CC]YY][.ss]
196