Environmental; Managed Devices - Tripp Lite B092-016 Owner's Manual

Chapter 14: Command Line Configuration

14.1.10 Environmental

To configure an environmental monitor with the following details:
Monitor name
Monitor Description
Temperature offset
Humidity offset
Enable alarm 1 ?
Alarm 1 label
Enable alarm 2 ?
Alarm 2 label
Logging enabled ?
Log interval
# config -s config.ports.port3.enviro.name=Envi4
# config -s "config.ports.port3.enviro.description=Monitor in room 5"
# config -s config.ports.port3.enviro.offsets.temp=2
# config -s config.ports.port3.enviro.offsets.humid=5
# config -s config.ports.port3.enviro.alarms.alarm1.alarmstate=on
# config -s config.ports.port3.enviro.alarms.alarm1.label=door alarm
# config -s config.ports.port3.enviro.alarms.alarm2.alarmstate=on
# config -s config.ports.port3.enviro.alarms.alarm2.label=window alarm
# config -s config.ports.port3.enviro.alarms.total=2
# config -s config.ports.port3.enviro.log.enabled=on
# config -s config.ports.port3.enviro.log.interval=120
It is important to assign alarms.total=2 even if they are off.
The following 5 commands will add the environmental monitor to 'Managed devices':
To get the total number of managed devices:
# config -g config.devices.total
Make sure to use the total + 1 for the new device below:
# config -s config. devices.device5.connections.connection1.name=Envi4
# config -s "config. devices.device5.connections.connection1.type=EMD Unit"
# config -s config. devices.device5.name=Envi4
# config -s "config. devices.device5.description=Monitor in room 5"
# config -s config.devices.total=5
The following command will synchronize the live system with the new configuration:
# config -a

14.1.11 Managed Devices

To add a managed device: (also see UPS, RPC connections and Environmental)
# config -s "config.devices.device8.name=my device"
# config -s "config.devices.device8.description=The eighth device"
# config -s "config.devices.device8.connections.connection1.name=my device"
# config -s config.devices.device8.connections.connection1.type=[serial | Host | UPS | RPC]
# config -s config.devices.total=8
To delete the above managed device:
# config -d config.devices.device8
The following command will synchronize the live system with the new configuration:
# config -a
Envi4
Monitor in room 5
2
5
yes
door alarm
yes
window alarm
yes
120 seconds
(decrement this value when deleting a managed device)
190