Table of Contents
Advertisement
After you have set the UPS address, you can return to the main
setup screen by typing 0 and pressing Enter.
NOTE:
The UPS address you set must correspond to the address
of the UPS you want the SNMP adapter to communicate
with.
Display Settings
This screen displays all of SNMP Solo's current settings. To
access this screen, type 5 at the prompt from the Main Menu.
The current settings display:
Figure 10 Display All Current Settings
The settings are the following fields:
•
Local, SNMP Solo's, Address and serial number (physical
address)
•
Gateway and Network address
•
System Contact Name (Your system administrator's or a
contact's name)
•
System Name
Tripp Lite
Configuration
19
Advertisement
Table of Contents
