Table of Contents
Advertisement
Serial Port
The SNMP Solo uses this port for configuration during
installation or for communications during normal operations.
Two 3.5" Diskettes
Your package contains two 3.5" MIB diskettes—one in DOS
format and one in TAR format. These diskettes contain the UPS
MIB file. Copy the MIB file to the appropriate NMS MIB
directory for the UPS connected to your SNMP Solo.
The DOS disk also contains a copy of the programmed image
file and the downloaded .exe program. See the Upload
Firmware section for further explanation of these files.
Configuration Cable
Your package contains a cable labeled SM-SER-117A, female-
to-female. Use this cable to connect the SNMP Solo serial port
and a dumb terminal or PC for configuration. When you
configure the SNMP Solo, be sure to set the DIP switch to the
proper setting. Any dumb terminal or terminal emulation
package, such as Microsoft Windows' Terminal will work fine.
Power Supply
The two types of power supplies offered are:
Power Supply Type
Wall Cube
Universal
WARNING: If you are using a power supply other than the one supplied
with the SNMP Solo, be sure that the polarity of the new
power supply is correct. If the polarity of the new power
supply is incorrect, you may run the risk of damaging the
adapter.
Input
120 VAC, 60 Hz
230 VAC, 50 Hz
SNMP Solo Package
Tripp Lite
Output
9 VDC, 1 amp
9 VDC, 1 amp
5
Advertisement
Table of Contents
