Making Copies; Your Machine's Copier Features; Basic Copy Procedure; Single Copy - imagistics DL170 Operating Manual

Basic operation

Making copies

Your machine's copier features

Your machine has the following copier features:
• Single copy (see the right column on this page)
• Stacking multiple copies (see page 2.12)
• Sorting multiple copies (see page 2.12)
• Enlarged or reduced copies (see page 2.13)
• Negative/positive copy (Reverse black and white areas) (see page 2.16)
• Combine copy (see page 2.17)
• Ultra copy mode (see page 2.17)

Basic copy procedure

1
Press / to change to
COPY FAX
Copy mode.
When the machine is in the Copy mode, the
Note: For details about each item, see "Making copy settings," page 2.15
2.12
COPY/FAX key
shows:
LCD
Number of copies
Copy reduction or enlargement ratio
Recording paper size
Document size
2
Place your original document in ADF face up, or on the FBS glass face
down just as you would to send a fax.
3
Enter the document size by pressing the
4
As needed, set the following:
• Select document type and adjust image contrast
• Enter the number of copies
• Set copy reduction or enlargement ratio
Note: For details about each item, see "Making copy settings," page 2.15.
5
Press .
START
Note: To reset the copy parameter to default setting, press
Note: To stop the copying, press
STOP

Single copy

1
Press / to change to Copy mode.
COPY FAX
2
Place your original document in ADF face up, or on the FBS glass face
down just as you would to send a fax.
3
If you are using FBS glass, enter the document size by pressing the
.
DOCUMENT SIZE
4
As needed, set the following:
• Select document type and adjust image contrast
• Set copy reduction or enlargement ratio
Note: If you want to enlarge copy, use the
5
Press .
START
.
DOCUMENT SIZE
.
COPY RESET
.
glass.
FBS