imagistics DL170 Operating Manual page 132

Just in case ...
What you see on the
LCD
Document Full
Document Jam
ContStor Enter/Cancl
Document Stored
Enter No. (0-32)
Enter No. (000-255)
Enter Reduce/Enlarge
Enter Scan Size
Feeder In Use
5.6
What it means/What to do
You tried to enter an document into an F-Code
box, but the machine has reached its capacity
(30 documents). Delete documents stored in
F-Code boxes until the machine will let you pro-
ceed.
An original document jam while you are using
the ADF for either faxing or copying. See page
5.1 for instructions on clearing the jam.
You tried to erase a batch box which contains at
least one document. Erase the document(s), then
try again.
You tried to enter a call group number greater
than 32. Your machine can maintain 32 call
groups, numbered 1-32 (call group 0 covers all
the groups). Determine the correct call group
identifier number and enter it, instead.
If the optional NIC (network interface card) is
attached to your machine, and you tried to enter
a TCP/IP address greater than 255.
Enter the correct TCP/IP address.
The calculated reduction or enlargement ratio is
out of the acceptable range (50 – 200 %) when
the copy reduction or enlargement ratio is set to
"Auto". Enter the reduction or enlargement ratio
manually but a part of the image may be miss-
ing. The paper can also be changed for copying.
When using the FBS (Flatbed scanner) glass,
you must manually enter the scan size of your
document. Press to choose the
DOCUMENT SIZE
size.
The command you're trying to enter requires the
use of the , which is already in use. Wait for
ADF
the machine to stop using the , then try
ADF
again.
What you see on the
LCD
Hang Up Phone
In Relay Box
In Secure Box
In Use in P OneTouch
Invalid I.D. Code
Invalid Number
Invalid Paper Size
Invalid Passcode
Line Busy
What it means/What to do
The optional handset is off-hook.
Hang it up, making sure the upper part of the
handset presses down on the "hook" button.
You tried to store a document for polling in an F-
Code box which is set to be a relay box.
Select an F-Code box which is set to be a bulletin
box, then try again.
You tried to store a document for polling in an F-
Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
You tried to erase the F-Code box or Batch box,
which is programmed in the programmable one-
touch key.
Erase the programmable one-touch key that con-
tains the F-Code box or Batch box you want to
erase, then try again.
The F-Code box . . code you entered isn't valid.
I D
Try re-entering your F-Code box . . code.
I D
You pressed a key which has no function during
the current operation.
If the optional printer controller is attached to
your machine, it can use the special sized paper
with the bypass tray. However, it should be used
only for the PC printing, it cannot be used for
copying. So, if you tried to copy onto the special
sized paper with bypass tray, this message will
appear.
The protection passcode you entered isn't valid.
Repeat the operation, entering the correct protec-
tion passcode.
You tried to erase a document which someone is
polling from your machine. Wait for the fax to
complete the polling operation, then try again.