imagistics DL170 Operating Manual page 92

Advanced features
17
Press . The asks you for the type of confirmation report you want to
ENTER LCD
set for this programmable one-touch number.
Report
/ /Enter
18
Press until the report you want appears.
19
Press . The asks if you want to send a cover page for this program-
ENTER LCD
mable one-touch number.
Cover Page
/ /Enter
20
Press until the mode you want appears.
21
Press . The asks if you want to turn the Fax & Copy feature on or
ENTER LCD
off for this programmable one-touch number.
Fax & Copy
/ /Enter
Note: When memory transmission is set to off in step 15, this message will
not appear. Go to step 24.
22
Press until the mode you want appears.
23
Press .
ENTER
24
Press to return your machine to standby mode.
STOP
3.38
:---
:---
:---
Programming a broadcast / group
Programming a broadcast is very similar to programming a delayed transmission.
But instead of sending to just one phone number, you set up multiple numbers for
the transmission.
To program a broadcast / group into a programmable one-touch key:
1
Press Program key, , 3, 0, 1,
A
grammable one-touch number available:
Select Program No.
P2:No Number Stored
Note: If P2 appears on the
LCD
number for P1. You can see what you programmed into P1 by pressing
, if you want. For example, if you set P1 for storing of the polling
document, you will see:
Select Program No.
P1:Polling Document
Press to go back to the programmable one-touch key you want to
enter.
Note: To erase a programmable one-touch key, see page 3.49.
2
Press the key that you want to program or change. Here, we've selected P2.
Select Program No.
P2:No Number Stored
Note: If you're changing a previously stored command: If your previous com-
mand for this key was a for a broadcast/group transmission, and you
want to keep this key programmed for a broadcast/group transmis-
sion, use these instructions to make changes. But if you want to
assign this key to a completely different operation for batch transmis-
sion, then you must first erase the stored command before
programming the new one.
3
If you want to select a different programmable one-touch key than what
appears on the , press that key now.
LCD
4
Press . The asks which operation you want to program into the pro-
ENTER LCD
grammable one-touch:
Type :Communication
/ /Enter
Note: If changing a previously stored command, skip to step 7.
. The shows the first empty pro-
ENTER LCD
, it means that you have already entered a