Adjust The Monitor Speaker's Volume; Loading Paper - imagistics DL170 Operating Manual

Getting started

Adjust the monitor speaker's volume

You can set the volume of the monitor speaker.
1
Press / on the control panel. You now should hear a dial tone.
MONITOR CALL
And press or of the cursor key. The
** Tel Mode
Volume:
2
To turn the volume up, press .
To turn the volume down, press .
3
Press / again to hang up.
MONITOR CALL
1.8
indicates the volume:
LCD
**

Loading paper

Acceptable paper size and cassette capacity
Paper source Paper type Paper size
Paper cassette Plain paper* 1 Letter
Letter
Plain paper* 1 A4
Bypass Tray Executive , Custom-sized*
Envelopes DL
Postcard 3.9" x 5.8"
Transparency* 3 Letter
* 1 Paper weight: 60 – 90 g/m 2
* 2 (3.8 – 8.5) inches ˘ (5.5 – 14.0) inches
optional Printer Controller is attached.
* 3 We recommend: 3M PP2500 for laser printers or equivalent
Note: Do not use any paper which has been creased, wrinkled or has absorbed any
moisture.
Loading paper in paper cassette
Before you load paper, note the following:
• After you loaded paper in paper cassette, you need to "tell" your machine which
paper size, letter—-, legal—- or half letter—-sized, you loaded.
You can do this by the "Setting of the paper size" operation. (See next page.)
Note: If you will be using letter—-sized paper, there's no need to adjust the cas-
sette; your machine is initially set for Letter—-sized paper. Simply attach
the LTR sticker to the outside of the paper cassette.
1
Open the paper cassette from the front of your machine by gently pulling it
toward you.
Capacity
, Legal , Half-letter 500 sheets
, Legal , Half-letter ,
, A5 , A6 , F4 , 50 sheets
2
, CM10 , Monarch 1 sheet
x 20 sheets
(100 148mm)
20 sheets
: It only can use if the
(Width ˘ Length)