Installing The Printing Supplies - imagistics DL170 Operating Manual

Getting started

Installing the printing supplies

Your fax prints incoming faxes and copies with a reliable 600 dpi print engine. Your
fax requires two types of printing supplies (sometimes also called consumables):
• The drum unit —- It yields 16,000 "normal" letter—-sized printouts (see
"Specifications," pages .1–
AI
text and/or graphics on each page. This is based on an industry—-standard test
document.
• The toner cartridge —- It yields 10,000 "normal", letter—-sized printouts (see
"Specifications," pages .1–
AI
To install these supplies:
Important: Gently close the top cover so that you don't catch your hands, possibly
injuring them.
1
Pull up the top cover
release and open the top
cover.
2
Slide the printer cover
release and open the
printer cover.
3
Unpack a new toner cartridge from its
carton. Then, holding the toner car-
tridge with both hands, slowly shake it
to distribute the toner evenly inside the
cartridge.
Note: Do not touch the roller of the
toner cartridge.
1.6
.2). By "normal," we're referring to the amount of
AI
.2 and "the ITC-T test document #1,"
AI
4
Gently install the toner cartridge in
the printer, making sure the toner car-
tridge's two pins fit in the slits inside
the printer frame.
.9).
AI
5
Unpack the drum units from its carton.
Note: Shield the drum units from light, especially strong light. Later, if you
6
Gently install the drum unit in the
printer, making sure the drum unit's
four pins fit in the slits inside the
printer frame.
7
Gently clean the LED print head
using the cleaning paper included in
the toner cartridge carton box.
For best print quality, you should
clean the LED head every time you
change the new toner cartridge.
Note: Do not use abrasive materials
8
Gently close the printer cover.
9
Close the top cover. Be sure to push on a portion of the cover to lock it into its
original (closed) position.
Note: The fax machine will not work if the cover isn't closed properly.
have to remove the units from the machine, immediately wrap it in a
thick cloth to protect it from light.
on the LED print head, and
do not subject the LED print
head to strongly shock.