imagistics DL170 Operating Manual page 97

18
Press . The asks you to select a contrast mode for each programma-
ENTER LCD
ble one-touch number.
Contrast :-------
/ /Enter
19
Press until the mode you want appears.
20
Press . The asks if you want the memory transmission on or off
ENTER LCD
when using this programmable one-touch number.
Memory Tx :---
/ /Enter
21
Press until the mode you want appears.
22
Press . The asks you for the type of confirmation report you want to
ENTER LCD
set for this programmable one-touch number.
Report :---
/ /Enter
23
Press until the report you want appears.
24
Press . The asks if you want to send a cover page for this program-
ENTER LCD
mable one-touch number.
Cover Page :---
/ /Enter
25
Press until the mode you want appears.
26
Press . The asks if you want to turn the Fax & Copy feature on or
ENTER LCD
off for this programmable one-touch number.
Fax & Copy :---
/ /Enter
Note: When the memory transmission is set to off in step 20, this
not appear and go to step 29.
27
Press until the mode you want appears.
28
Press .
ENTER
29
Press to return your machine to standby mode.
STOP
Programming F-Code polling
For this operation to work, two things must be true:
• The document which you're polling must exist in the remote fax's F-Code box (
standard sub-addressing/password box).
• You must know the remote fax's
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1
Press Program key,
grammable one-touch number available:
Select Program No.
P2:No Number Stored
Note: If P2 appears on the
number for P1. You can see what you programmed into P1 by pressing
, if you want. For example, if you set P1 for storing of the polling
document, you will see:
Select Program No.
P1:Polling Document
Press
enter.
Note: To erase a programmable one-touch key, see page 3.49.
2
Press the key that you want to program or change. Here, we've selected P2.
Select Program No.
P2:No Number Stored
Note: If your previous command for this key was for an F-Code polling oper-
ation and you want to keep this key programmed for an F-Code
polling operation, use these instructions to make changes. But if you
want to assign this key to a completely different operation (for a
delayed transmission, for example), then you first must erase the
stored command before programming the new one.
will
LCD
3
If you want to select a different programmable one-touch key than the one
that appears on the
4
Press
ENTER
grammable one-touch:
Type :Communication
- sub-address and password (if any) for each
ITU T
, 3, 0, 1, . The shows the first empty pro-
A ENTER LCD
, it means that you have already entered a
LCD
to go back to the programmable one-touch key you want to
, press that key now.
LCD
. The asks which operation you want to program into the pro-
LCD
/ /Enter
Advanced features
-
ITU T
3.43