imagistics DL170 Operating Manual page 37

Hide thumbs Also See for DL170:
Table of Contents

Advertisement

Sending a fax using the
1
Press
/
to change to Fax mode.
COPY
FAX
2
If there's a document in the ADF, remove it.
3
Open the platen cover.
4
Place the document face down on the
ment scale on the right, then gently close the platen cover.
The document should be aligned to the right front corner.
Important: Gently close the platen cover so that you don't catch your
hands, possibly injuring them.
When a thick document, such as a book, is on the
do not press strongly from the top of the platen cover. This
may break the
FBS
5
Press
to select the document size, letter (displayed as Ltr),
DOCUMENT SIZE
legal (Legl) or half-letter (HLtr). (Half-letter is 8.5" wide x 5.5" tall.)
6
Adjust resolution and contrast if necessary.
glass
FBS
glass and align it with the docu-
FBS
FBS
glass and cause an injury.
7
Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to "dial out" from an office telephone system, or 1 for
long-distance.)
Press Start
919725552009_
8
Press
START
By pressing
machine gives this action a command number as it scans the fax document.
This command number appears on the first line of the LCD for a few seconds:
== Command:01 ==
You'll need this command number to cancel the transmission or to print a
stored document (see pages 2.8–2.9).
Then your machine will scan the document into the memory.
While your machine scans the document, the
919725552009
Ltr
NextDoc Mem100%
9
When the scanning is done, the
Start Scan
Tx Start
glass,
If you want to send more pages, proceed to step 10.
Otherwise, press
10
Place the next page, then press
Note: If necessary, select the document size (see step 5).
To send any more pages, repeat steps 9-10.
Otherwise, press
11
Now, everything is up to the machines — yours and the one you're dialing.
When it makes contact, your machine transmits the stored document from
memory.
Important: If you want to cancel a transmission while scanning the docu-
.
, you've just given your machine a command. In turn, your
START
LCD
will show:
LCD
NextDoc
Start
to start the transmission, and skip to step 11.
START
to start scanning.
NEXT DOC
to start the transmission, and skip to step 11.
START
ment, press the
key.
STOP
If you want to cancel a transmission in progress, use the Review
Commands function. See "Reviewing or canceling commands,"
page 2.8.
Basic operation
will show:
2.5

Advertisement

Table of Contents
loading

Table of Contents