imagistics DL170 Operating Manual page 137

"Check Message" printouts
When your machine detects a communication error, it may produce an error print-
out headed by the words "Check Message." This printout lists the following
information about the transmission:
• The resulting error code
• A communications error message (see "What error messages can mean," below)
• The phone number (or , if programmed) of the fax machine with which your
TTI
machine had attempted to communicate.
What error messages can mean
The error messages on Check Message printouts can mean a variety of things.
Here's a brief summary:
Note: If TCR is turned "ON" transmit errors will be reported on the TCR, a "check
message" will not be printed.
Error message
Check condition of remote fax.
Repeat transmission.
Line is busy.
Check received documents.
Memory full.
Dialing number is not set.
Stopped.
Possible meanings
• Remote machine malfunctioned
• No "handshake" signals from remote fax
• Wrong phone number reached
• Poor phone line conditions
• No "handshake" signals from remote fax
• Document misfeed or miscount
• Unable to reach remote machine after
attempting specified number of redial tries
• Remote machine's line was busy
• Remote machine's line didn't answer
• Remote confirmation signal not received
from remote fax
• Poor line conditions caused a poor image
• Remote fax's memory is full
• Stored phone number failed to dial properly
• Someone pressed at the remote fax
STOP
in the middle of the "handshake"
Just in case ...
5.11