imagistics DL170 Operating Manual page 133

What you see on the
LCD
Macro In Use
Memory Overflow
Start Or Cancel
Mirror Carriage Error
Mirror Locked
No Command
No Department Code
No Document Stored
No Drum
No Number Stored
What it means/What to do
You tried to change the function for a Soft key,
but that Soft key has been programmed in a
Macro key. You cannot change the Soft key
function until you erase the Macro key that con-
tains the Soft key you want to change. Erase the
Macro key, then try again.
During transmission (or copying), you tried to
enter more pages into memory than your fax
could store. Press to tell your fax to keep
START
as many pages in memory as possible, or press
to delete from memory all pages stored
CANCEL
during this operation (but not previous opera-
tions).
The mirror carriage of your machine has become
inoperable. Call the ImagisticsDiagnostic
Center at 1 800 243 5556.
The transport mode is not turned off.
Turn off the transport mode (see page 1.8).
You pressed to review
REVIEW COMMANDS
upcoming commands, but your fax machine had
none stored.
You tried to turn on the department code setting
but there are no department codes stored in
your fax machine. Store at least one department
code, then try again.
. . . or . . .
You entered incorrect department code to send a
fax, while the department feature is on. Enter
correct department code.
You tried to print a document from memory, but
your fax machine had none stored.
The drum unit is missing or has not been prop-
erly installed in your fax machine.
Please properly install the drum unit.
You selected an autodialer, batch box or F-Code
box number for which there is no fax (or phone)
number programmed. Either choose another
number or dial a phone number directly from the
numeric keypad.
What you see on the
LCD
No Passcode
No PIN Number
No Report
No Toner Cartridge
Not Allowed in Macro
Other Key Setting
Open Top Cover
Please Remove Paper
Open 1st Side Cover
Please Remove Paper
Open 2nd Side Cover
Please Remove Paper
Open Top/2-Bin Cover
Please Remove Paper
Remove Bypass Paper
Open&Close Top Cover
Open&Close ScanCover
Reset Document
Please Call Service
What it means/What to do
You tried to program a security feature (see
page 3.50), but there's no protection passcode
stored in your fax machine. Store a protection
passcode in your machine, then retry again.
You selected "Mode1" in the mask feature
PIN
and tried to call an autodialer number in which
no PIN has been entered, or you tried to call
using numeric keypad without . Enter a
PIN
then try again.
You requested an activity journal or confirma-
tion report, but your fax machine has no record
of any fax jobs having occurred.
The toner cartridge is missing or has not been
properly installed in your fax machine. Please
properly install the toner cartridge.
During macro registration, you pressed a key
which cannot be registered in Macro, such as
Monitor/Call key or Security Reception key.
You tried to enter the same function which is
already stored in an another Soft key.
Store the different function.
The paper is jammed in your fax machine.
Open the cover indicated on the LCD, and
remove the jammed paper carefully.
Either your document wasn't inserted correctly,
or the fax to which you're sending can't handle
the document's page length. Reset the page and
try again.
The printer unit of your fax machine has
become inoperable. Call the Imagistics
Diagnostic Center at 1 800 243 5556.
Just in case ...
,
PIN
5.7