Removing A Magazine; Removing A Magazine Blank; Reinstalling A Magazine; Installing A Magazine Blank - Quantum SuperLoader 3 Supplementary Manual

Quantum SuperLoader3 Magazine and Magazine Blank Removal/Replacement Instructions
Document 81-81314-01 B01
October 2005

Removing a Magazine

0
Blank
Reinstalling a
0
Magazine
Installing a Magazine
0
Blank
4
Removing a magazine using the front panel
1 On the front panel menu, scroll to
2 Press on the front panel.
Enter
3 On the submenu, scroll to
Commands
front panel.
4 On the submenu, scroll to
Eject
depending on which magazine you want to eject, and then press
the front panel.
The magazine pops forward so that the front of the magazine is no longer
flush with the front panel.
5 With one hand, grasp the magazine by the handle and slide it forward to
remove. Place your other hand under the magazine to support it and
prevent it from falling.
Your autoloader comes equipped with either two magazines, or one
magazine and one magazine blank. The autoloader will not function without
both magazine bays equipped with either a magazine or a magazine blank.
To remove a magazine blank:
1 Pull the magazine blank straight out.
2 Replace with another magazine blank or a cartridge magazine (see
Reinstalling a Magazine).
To install a cartridge magazine:
1 Grasp the magazine by the handle with one hand and support it
underneath with the other hand.
2 Slide the magazine into the magazine bay. Make sure you position the
magazine correctly; it should slide smoothly.
Warning: Insert the magazine slowly to avoid damaging internal
components or the autoloader.
3 The magazine is correctly installed when you feel it click into place and
the front is flush with the front panel.
To install a magazine blank:
1 Grasp the magazine blank by the handle with one hand and guide the
blank into the magazine bay.
Replacing a Magazine or Magazine Blank
.
Commands
, and then press
Eject
or
Right Magazine Left Magazine
0
on the
Enter
,
on
Enter