Removing A Magazine; Removing A Blank; Installing A Magazine - Quantum SuperLoader 3A Series User Manual

Removing a Magazine

Removing a Blank

Installing a Magazine

Quantum SuperLoader 3A Series User's Guide
In most cases, you will remove a magazine by using the
4
on the front panel menu. If you need to remove the magazine when the
autoloader is powered off, you must remove it manually. Please contact
Customer Support for more information.
Removing a Magazine Using the Front Panel
1 On the menu, scroll to
2 Press
Enter
3 On the Commands submenu, scroll to
4 On the Eject submenu, scroll to
depending on which magazine you want to eject, and then press
.
Enter
The magazine pops forward so that the front of the magazine is no
longer flush with the front panel.
5 With one hand, grasp the magazine by the handle and slide it
forward to remove. Place your other hand under the magazine to
support it and prevent it from falling.
Your autoloader comes equipped with either two magazines, or one
4
magazine and one magazine blank. The autoloader will not function
without both magazine bays equipped with either a magazine or a
magazine blank.
To remove a magazine blank:
1 Pull the magazine blank straight out.
2 Replace with another magazine blank or a cartridge magazine.
To install a cartridge magazine:
4
1 Grasp the magazine by the handle with one hand and support it
underneath with the other hand.
Chapter 4 Customer Replaceable Units (CRUs)
Replacing a Magazine or Magazine Blank
Commands
.
Right Magazine
Eject
.
, and then press
Eject
or
Left Magazine
command
4
.
Enter
,
50