Using The Top Cover [Scan] Button - Fujitsu iScanner fi-6010N Operator's Manual

The idle time before standby mode entered can be changed. For details, refer to
Time to Standby Mode" (page
ATTENTION
HINT

2.2.2 Using the Top Cover [SCAN] Button

When the
[Scan] button or top cover [SCAN] button may be pressed to start the scan.
The touch panel [Scan] button may appear as follows:
[Scan]
[Scan & Send]
[Scan & Print]
[Scan & Save]
[Scan More]
66).
When the scanner is starting up or in standby mode, be careful to never
hold the startup button down for 4 seconds, as this will cause the scanner to
shutdown. If this happens, saved scanned data may become unusable.
If the startup button is accidentally held down too long, causing the scanner
to shutdown, temporally detach the AC adaptor to ensure that the power is
completely off.
After turning the power off, wait for at least 10 seconds before turning the
power back on again. To shutdown the scanner correctly, press the [Shut-
down] button on the "Login" screen.
Automatic login without displaying the "Login" screen is possible. For more
details about how to set automatic login, refer to
Method" (page 68).
icon is displayed in a [Scan] button on the touch panel, either the touch panel
2.2 Using the Scanner Buttons
"4.6.7 Setting the Login
[SCAN] button
(top cover)
fi-6010N Network Scanner Operator's Guide
"4.6.6 Setting the
2
27