Fujitsu iScanner fi-6010N Operator's Manual page 575

Screen
Send Fax Invalid fax number. Try again.
Invalid notification address (Sender's
e-Mail Address). Try again.
Current login (LDAP account) has
become invalid.
Add Fax Invalid fax number. Try again.
Number
Edit Fax Invalid fax number. Try again.
Number
Print Network is busy. Try again later.
Cannot find the network printer path.
Not connected to the network.
Access to network printer was refused.
Network path is too long.
Number of network path connections
has reached the maximum allowed. No
more may be specified.
Message
fi-6010N Network Scanner Operator's Guide
Action
Enter a valid fax number.
Only numbers 0 to 9, -,*, and # can
be used.
Enter a valid notification address.
Contact a system administrator to
have the login account validated.
Enter a valid fax number.
Only numbers 0 to 9, -,*, and # can
be used.
Enter a valid fax number.
Only numbers 0 to 9, -,*, and # can
be used.
Wait for a while, and try again.
Try the following:
Contact a server administrator.
Check that the spooler is
operating properly.
Check that the system network is
functioning normally by
performing a ping test from
another machine in the network,
other than the server with network
printer. If the system network is
not operating properly, refer to
"Failure to connect to a server
using its IP address" (page 463)
further solutions.
Contact a server administrator to
find out if an access permit has
been set.
Try the following:
Set a shorter printer alias.
Contact a system administrator
to have the network path
shortened.
Close unneeded network
connections, then try specifying
the desired network path again.
E
for
537