Checking The Ntp Server Settings By Synchronizing The System Time - Fujitsu iScanner fi-6010N Operator's Manual

■ Checking the NTP server settings by synchronizing the system
time
On the "NTP Server" screen, press the [Sync Time] button to check if the system time can be syn-
chronized.
After pressing the [Sync Time] button, follow each action described below according to the mes-
sage that is shown.
Message
System time has been suc-
cessfully synchronized.
System time synchronization
failed.
8.3 Network Connection Troubleshooting
None
Try the following:
Check the specified NTP server IP address, host name, or
FQDN for mistakes, and correct them.
Check the network path between to the NTP server for
problems.
The NTP server may be busy. Wait a short time before try-
ing again to synchronize the system time. If that does not
work, the specified server may not be an NTP server, so
try a different NTP server.
The specified NTP server cannot provide a trusted date
and time. It attempted to acquire the date and time from a
higher level NTP server, but failed. Try a different NTP
server or have the network administrator investigate.
Check that the time is correct.
If the time is incorrect, adjust the date/time, and try again.
Refer to "4.6.5 Setting the Date/Time" (page
the date/time, and try again.
fi-6010N Network Scanner Operator's Guide
Action
64), adjust
8
461