Concluding Steps; Replacing The Processor Heat Sink; Preliminary Steps - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

11.2.7 Concluding steps

"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 75
"Enabling SVOM boot watchdog functionality" on page 85
Ê
"Enabling BitLocker functionality" on page 90
Ê
11.3

Replacing the processor heat sink

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

11.3.1 Preliminary steps

"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing the fan module" on page 151
Ê
11.3.2 Replacing the processor heat sink
Ê Remove the processor heat sink as described in section
processor heat sink" on page
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page
TX140 S2
219.
223.
Upgrade and Maintenance Manual
Hardware: 15 minutes
"Removing the
Processors
227