Concluding Steps - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

14.5.5 Concluding steps

Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section
page 225
– Memory modules: refer to section
page 213
I
Install all memory modules into their original slots.
– Expansion cards: refer to section
page 213
I
Install all expansion cards into their original slots.
– UFM (if applicable): refer to section
– TPM (if applicable): refer to section
"Installing the fan module" on page 152
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
"Reassembling" on page 58
Ê
Ê Reconnect all external cables.
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
"Updating or recovering the system board BIOS and iRMC" on page 75
Ê
"Verifying system information backup / restore" on page 79
Ê
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and the password.
TX140 S2
"Cabling plans" on page
"Installing the processor heat sink" on
Upgrade and Maintenance Manual
System board and components
301.
"Installing a memory module" on
"Installing a memory module" on
"Installing the UFM" on page 255
"Installing the TPM" on page 262
283