Shutting Down The Server; Disconnecting The Server From The Mains - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Basic hardware procedures
4.2

Shutting down the server

V
CAUTION!
For further safety information, please refer to chapter
information" on page
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Perform the required procedures described in the preliminary steps of each
upgrade or maintenance task.
Ê Shut down the server.
I
If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section
4.3

Disconnecting the server from the mains

Figure 2: Removing the power cord from the cable tie
Ê Pull out on the locking lever on the cable tie (1) and loosen the loop (2).
46
31.
"Locating the defective server" on page
Upgrade and Maintenance Manual
"Important
43.
TX140 S2