Table of Contents
Advertisement
Before you start
Replacing a defective component
The global error indicators on the front and rear sides of the server as well as
local diagnostic LEDs on the front panel report defective hardware components
that need to be replaced. For further information on the controls and indicators
of your server, refer to the "PRIMERGY TX140 S2 Server Operating Manual"
and section
"Connectors and indicators" on page
If the system has been powered off in order to replace a non-hot plug unit, a
system of PRIMERGY diagnostic indicators guides you to the defective
component. The "Indicate CSS" button enables the indicator next to the
defective component even if the server has been switched off and disconnected
from the mains. For further information, please refer to sections
diagnostics information" on page 43
front panel" on page
If the defective component is a customer replaceable unit included in the CSS
concept (Customer Self Service, only available for EMEA market), the CSS
indicators on the front and rear side of the server will light up.
For further information, refer to the "ServerView Suite Local Service Concept
(LSC)" manual available online at
http://jp.fujitsu.com/platform/server/primergy/manual/
It is recommended to prepare local maintenance tasks using remote diagnostics
procedures, as described in the "ServerView Suite Local Service Concept
(LSC)" manual.
2.1
Classification of procedures
The complexity of maintenance procedures varies significantly. Procedures
have been assigned to one of three unit categories, indicating the level of
difficulty and required qualification.
At the beginning of each procedure, the involved unit type is indicated by one of
the symbols introduced in this section.
I
Please ask your local Fujitsu service center for more detailed
information.
22
and
326.
http://manuals.ts.fujitsu.com
Upgrade and Maintenance Manual
320.
"Connectors and indicators on the
(Japanese market).
"Using
(EMEA market) or
TX140 S2
Advertisement
Table of Contents
