Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual page 238

Accessible drives
Figure 149: Inserting the accessible drive
Ê Insert the accessible drive into its installation bay and carefully push in until
the front screw hole on the front panel frame lines up with the centering pin
on the locking bar (1).
V
CAUTION!
For installing a LTO drive: ensure that the power cables routed behind
the accessible drive cage are not trapped when pushing the LTO
drive in its bay.
Ê Close the locking bar (2) until it locks in place (3).
Ê Connect the cables according to your configuration see section
plans" on page
I
Notes on RDX drive USB cabling:
– A USB 2.0 RDX drive may be replaced by a USB 3.0 RDX drive with
previous cabling.
– A USB 3.0 RDX drive may be connected with a USB 2.0 cable to the
onboard USB 2.0 connector with limited performance.
– For full performance, connect the USB 3.0 RDX drive to a USB 3.0
PCI interface card by USB 3.0 cable.
– The USB 3.0 cable cannot be connected to a USB 2.0 RDX drive.
238
301.
Upgrade and Maintenance Manual
"Cabling
TX140 S2