Concluding Steps; Converting A Standard Power Supply To A Redundant Power Supply; Preliminary Steps - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Power supply
6.3.4.5

Concluding steps

"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
"Enabling BitLocker functionality" on page 90
Ê
6.4 Converting a standard power supply to a
redundant power supply
The standard power supply can be replaced by a redundant power supply. The
redundant power supply consists of up to two power supply units (slide-in units).
The upgrade kit contains only one power supply unit (for power supply
redundancy the second power supply unit must be additionally ordered).
The upgrade kit for the redundant power supply consists of the following parts:
– PSU cage with power distribution board (incl.power cables)
– one hot-plug power supply unit
– dummy cover (if only one power supply unit is installed, you have to install
the dummy cover in the second bay)
– several screws
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
6.4.1

Preliminary steps

"Disabling BitLocker functionality" on page 69
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing the fan module" on page 151
Ê
116 Upgrade and Maintenance Manual
Hardware: 10 minutes
TX140 S2