Concluding Steps - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Ê Connect the power connector P1 to system board connector "PWR1" (2)
(see section "Cabling plans" on page
Ê Route the power cables in the corresponding cable clamps (see circles).
Ê Install the power supply unit(s) as described in
supply unit" on page
Ê If one bay remains empty, install the dummy cover as described in
the dummy cover" on page
6.4.4

Concluding steps

"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
"Enabling BitLocker functionality" on page 90
Ê
TX140 S2
108.
111.
Upgrade and Maintenance Manual
301).
"Installing a hot-plug power
Power supply
"Installing
119