Removing The Defective Expansion Card; Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.3.2

Removing the defective expansion card

Ê If applicable, remove SFP+ transceiver modules from the expansion card to
be removed, as described in section
module" on page
Ê Remove the expansion card as described in section
cards" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
page 169.
9.4.3.3

Installing the new expansion card

Ê If applicable, install a slot bracket on the expansion card as described in
section "Installing a slot bracket" on page
Ê Install the expansion card as described in section
cards" on page
Ê If applicable, reinstall SFP+ transceiver modules on the expansion card, as
described in section
9.4.3.4

Concluding steps

"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
"Enabling replaced components in the system BIOS" on page 85
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 92.
"Updating the NIC configuration file in a Linux environment" on page 89
Ê
"Updating RAID controller firmware" on page 80
Ê
"Enabling SVOM boot watchdog functionality" on page 85
Ê
"Enabling BitLocker functionality" on page 90
Ê
184
173.
180.
176.
"Installing SFP+ transceiver modules" on page
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
"Removing an SFP+ transceiver
"Removing expansion
"Removing a slot bracket" on
162.
"Installing expansion
170.
TX140 S2