Rebooting The Autoloader (Operations> Reboot Autoloader); Enabling Password Locks (Operations > Enable Autoldr Password Locks); Support; Powering A Drive On Or Off (Support > Power On/Off Drive) - HP BL536A User's & Service Manual

NOTE: This command is only needed if the inventory in the device is different than the inventory
displayed on the front panel, which would not happen under normal conditions.
Rebooting the Autoloader (Operations> Reboot Autoloader)
This option reboots the device and forces a new cartridge inventory, clearing any current error
condition.
CAUTION:
to fail. Use this option if the device is in an error state.
To reboot:
1. From the Home screen, press Previous or Next until the screen displays Operations. Press Enter
to select.
2. Press Previous or Next until the screen displays Reboot Autoloader. Press Enter to select.
3. The Ready LED blinks during the reboot operation.
Enabling password locks (Operations > Enable Autoldr Password Locks)
This option locks the restricted areas. This is typically used if you do not want to wait for the time
out to reset the locks. Power cycling or rebooting the device also resets the locks.
To enable the password locks:
1. From the Home screen, press Previous or Next until the screen displays Operations. Press Enter
to select.
2. Press Previous or Next until the screen displays Enable Autoldr Password Locks. Press Enter
to select.

Support

The Support menu provides access to the following support options:
Powering a drive on or off (Support > Power On/Off Drive) (page 81)
Running the demonstration (Support > Run Demo) (page 82)
Running the slot to slot test (Support > Run Slot To Slot Test) (page 82)
Running the wellness test (Support > Run Wellness Test) (page 82)
Upgrading firmware (Support > Autoloader FW Upgrade, Support > Drive FW Upgrade)
(page 83)
Viewing logs (Support > Autoloader Error Log) (page 84)
Downloading a support ticket (Support > Download Support Ticket) (page 84)
Forcing the drive to eject a tape (Support > Force Drive To Eject Tape) (page 85)
To access the Support menu:
1. From the Home screen, press Previous or Next until the screen displays Support. Press Enter
to select.
2. Press Previous or Next until the screen displays your selected function. Press Enter to select.
Powering a drive on or off (Support > Power On/Off Drive)
Use this option to power a drive on or off without interrupting power to the rest of the device.
Access to this feature requires the administrator password.
To power on or off the drive:
1. From the Home screen, press Previous or Next until the screen displays Support. Press Enter
to select.
2. Press Previous or Next until the screen displays Power On/Off Drive. Press Enter to select.
This option interrupts the current backup or restore operation and causes the operation
Operator control panel (OCP) 81