Editing The Emc Call Home Center - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

14. Enter a password in the SMTP Server Settings - Password field.
15. Enter the e-mail address for replies in the E-mail Notification Settings - Reply Address field.
16. Enter the customer e-mail address in the E-mail Notification Settings - Send To Address field.
17. Click Send Test to test the mail server.
18. Click OK.
19. Click OK to close the Call Home Configuration dialog box.

Editing the EMC call home center

To edit an EMC call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
2. Select the EMC call home center you want to edit in the Call Home Centers table.
3. Click Edit Centers (beneath the Call Home Centers table).
FIGURE 51
4. Make sure the EMC call home center type displays in the Call Home Centers list.
5. Select Enable to enable this call home center.
6. Set the time interval at which to check the call home center by selecting the Set the heartbeat
DCFM Professional Plus User Manual
53-1001774-01
This is a required field when the SMTP server authentication is enabled.
The selected call home center must be enabled to test the mail server.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
The Call Home Configuration dialog box displays with the call home center you edited
highlighted in the Call Home Centers table.
The Call Home dialog box displays.
The Configure Call Home Center dialog box displays
Configure Call Home Center dialog box (EMC option)
interval at ___ days (1-28) check box and entering the interval in the field.
(Figure 51).
4
113