Changing The Seed Switch - HP Brocade BladeSystem 4/12 User Manual

2
Seed switch

Changing the seed switch

When you change the seed switch for a fabric, the Management application performs the following
checks in the order they are listed:
•
•
•
•
•
To change the seed switch, complete the following steps.
1. Select Discovery > Setup.
2. Select the fabric for which you want to change the seed switch from the Discovered Addresses
3. Click Change Seed Switch.
54
Identifies all switches and removes those running unsupported firmware version.
Identifies which of the remaining switches are running the latest firmware versions.
Filters out those switches that are not reachable.
Identifies which switches are Virtual Fabric-enabled switches (Fabric OS only).
If there are Virtual Fabric-enabled switches, the Management application only uses these
switches as recommended seed switches. If there are no Virtual Fabric-enabled switches,
continue with the next check.
Identifies which switches are Virtual Fabric-capable devices (Fabric OS only).
If there are Virtual Fabric-capable switches, the Management application only uses these
switches as recommended seed switches. If there are no Virtual Fabric-capable switches, the
Management application uses the list from the second check.
The Discover Setup dialog box displays.
table.
If a device joins or merges with a fabric and fabric tracking is active, you must accept changes
to the fabric before the new devices display in the Change Seed Switch dialog box. For more
information about fabric tracking, refer to
If the fabric contains other switches that are running the latest version and are also
HTTP-reachable from the Management application, the Change Seed Switch dialog box
appears. Otherwise, a message displays that you cannot change the seed switch.
"Fabric tracking" on page 98.
DCFM Professional User Manual
53-1001773-01