Deleting A Zone - HP Brocade BladeSystem 4/12 User Manual

Using the following procedure you can do the following:
•
•
•
NOTE
You must have the Zoning Set Edit Limits privilege to perform this task.
1. Select Configure > Zoning > Set Change Limits.
2. Click Change Count for the fabric on which you want to set limits.
3. Enter the maximum number of zone database changes that can be made for that fabric before
4. Repeat
5. To set a limit for new, undiscovered fabrics, enter a value in the Default Change Count for New
6. Select the Enforce change limits during zone activation check box to enforce the change limits.
7.

Deleting a zone

1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select one or more zones in the Zones list that you want to delete, then right-click and select
5. Click Yes to delete the selected zone.
DCFM Professional User Manual
53-1001773-01
Set a different limit for each fabric.
Set limits on some fabrics while allowing other fabrics to have unlimited changes.
Set a limit for fabrics that will be discovered later.
The Set Change Limits for Zoning Activation dialog box displays.
The field changes to an editable field.
a zone configuration is activated.
To set a limit, enter a positive integer.
To allow unlimited changes, enter 0.
step 2 and step 3
Fabrics field.
The default value is 0 (Unlimited).
If you want to set the limits now, but turn on enforcement of the limits at a later time, make
sure the check box is clear.
Click OK to save your changes and close the dialog box.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Delete.
A message box displays asking you to confirm the deletion.
The message box closes and, if successful, the zone or zones are removed from the Zones list.
for each fabric on which you want to set limits.
Zoning administration
15
469